On I go…
Two more screws on the left receiver half.
The barrel comes free.
I assume this nut is to adjust the gap between the pellet shuttle and the barrel.
The pellet cam rod, shuttle, etc.
The shuttle does not have a setscrew to lock it on the rod the way the model 600 does.
Spring on the end of the valve stem extension/transfer rod.
It slides out of the valve assembly.
Piercing pin nut.
Removed, the mesh filter comes out as well.
Piercing pin parts.
The seal is a metal ring with a rubber center. Odd. In theory I should be able to use the piercing pin and seal used on the Model 38 pistol, I hope.
Valve stem housing.
The valve seems to be the same as on the Model 38 revolver.
Seal inside the nut.
This plastic piece is loose, but retained by a staked steel washer. I’m going to keep it in place, unless forced by circumstances to replace it.
Now to clean and get together some replacement parts & seals.