Mounting a Williams Sight on a Crosman 167, Part 2

So I need some longer mounting screws...

Turned and threads cut.

And cut off.

Slotting.

The lower base hole needed to be elongated.

As did the shim.

A tiny vise holds the sight blade (? insert?) and I slot it deeper.

And mill the top down. The goal was to have it roughly in the middle of the adjustment range when the rifle was zeroed at 10 yards.

I slapped some paint on the exposed aluminum. Mounted solidly. I think I could get away without using a shim if I could overlook the gap between the barrel and the base.

a bunch of shots to sight it in and then 5 shots in a row (only at 7 yards...too dark outside) pretty much on center.

Mounting a Williams Sight on a Crosman 167, Part 1

I love my Crosman 167, but I absolutely hate the cheap stamped rear sight. Recently I bought a lot of random Williams rear sights on Ebay, for about $5.00 a piece. So I set about adapting one to the Crosman.

The Williams sight and existing sight. Windage is adjusted by loosening one screw and pushing the sight over.

Elevation adjustment is achieved by pushing in or out the notched ramp.

The Williams sight, while not a micrometer sight, has clearly marked index scales and is much easier to adjust.

Mounted in one screw hole, you can see that the other hole is not in the right place. I could tap the barrel, but I prefer to keep it in stock form (or easily reversible).

The sight base has too large a radius.

A piece of aluminum was turned to the radius of the sight base (I got it close and then checked until it seemed to have full contact.) Then it was offset eccentrically in the chuck.

Drilling begins.

Drilled out to 1/2"

Then to 9/16". The Taig isn't ideal for drilling with larger drills, but in aluminum it works fine.

Parted off.

With a plug inserted, and held in a vee block, the eccentric piece is adjusted.

Sawing off my shim...

The shim fits perfectly.

The underside.

Marking one screw hole.

More to come...