Most of my airgun projects are driven by the need to solve perceived problems or annoyances. I have a lot of air pistols with anatomic target grips and I've noticed that the palm shelves on some guns will occasionally move slightly unless the mounting bolt is pretty tight. I wondered if there was a way to lock the palm shelf in position without resorting to cranking the bolt to the limit of torque. Anyway, here's a quick modification that I found beneficial.
Came across a few 3/8" diameter rubber discs.
These are 1/8" thick.
I milled two 0.375" diameter pockets about .100" deep on the inside of the Hammerli's palm shelf. A pocket on each side of the mounting bolt.
The rubber washers push in and barely stand proud.
The amount they stick out is adjustable by cutting to different depths and/or shimming
The shelf now locks in place at substantially less bolt torque. Roughing up the rubber discs with some sandpaper would've probably also helped.
More soon.
Now THAT'S a brilliant solution!
ReplyDelete