Friday, November 19, 2010

Crosman Model 99, Driving Me Nuts, Part 1

The title says it all. I started by trying to tighten up the pellet feed mechanism, successfully. I stole the cam ring from the beater model 600 pistol.11191016

The ring binds on the cam rod.

11191001

I had to do a little operating on the ring.

11191002

Just some work on the corners and chamfering the edges. Red line shows how much metal is contacting the cam rod.

11191003

Still locks up on the cam rod.

11191004

More polishing of the corners of the cam rod and now it feeds fine, very little play.

11191005

The slow leak was bothering me though. Removed the exhaust seal. It was the opposite of pliable.

11191006

Making a new seal.

11191007

Cut off. Then installed. But it was still leaking.

11191008

The seal where the valve stem passes through the body was troubling me. I took apart a Crosman model 38 valve to see if I was missing something. That washer…I didn’t notice it in the 99 valve.

11191009

Found it.

11191010

Down in the valve was a rubber seal and a plastic sleeve.

11191011

On later model 38’s they use an o-ring but the original seal (center) looks like a flat ring. Skipping ahead, I think this might be one of the reasons I ‘m having a leak. I’ll be making a flat ring seal later to test this theory out.

11191012

The washer, new o-ring and plastic sleeve.

11191013

The valve stem is the same as the model 38 valve stem.

After taking it apart several times, making another seal, wasting about 4 CO2 cartridges, still not finding the leak (if anything the leak was getting worse), I decided to build a test unit.

11191014

Empty (!!!) CO2 cartridge tapped for an air fitting. Only about 2 threads holding it in, so I didn’t hook it up to my big compressor, just the little paint compressor.

11191015

The compressor. At least I won’t be wasting 40 cents every time I test the valve. Unless of course it leaks at low pressure and seals at higher pressures, in which case I’m screwed.

In any case, I’m going to take a break from this rifle for a little while as I have an even more complex project that I want to get to next week.

2 comments:

  1. Was a kid with a pellet rifleDecember 30, 2011 at 7:20 PM

    You took a little break and it's been more than a year! :-) Did you quit or just not posted the continuation?

    I was looking at this because I have a Model 99 in a closet here. I haven't looked at it in decades and wondered if it would work. I presumed the rubber ring/seal around the piercing pin would be stiff and brittle and need some kind of replacement, but it seems there's other stuff that may need replacing too. I wouldn't get in to this as seriously as you do, and you have the know how, the tools and materials I don't. :-)

    But thanks for the info and documenting the job, it's appreciated.

    Good luck,
    Ivan

    ReplyDelete
  2. Ivan,
    I just got tired of it as I wasn't having much luck getting it running right. I'll probably pick it up again now that I have more time this winter.

    ReplyDelete